Table of Contents
Advertisement
Figure 74. Installing the MicroSD card
Next steps
1.
Install the IDSDM
module.
2. Follow the procedure listed in
Optional internal USB card
NOTE:
To locate the internal USB port on the system board, see the
Removing the internal USB card
Prerequisites
CAUTION:
To avoid interference with other components in the server, the maximum permissible dimensions of
the USB memory key are 15.9 mm width x 57.15 mm length x 7.9 mm height.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Steps
1. Holding the blue tag, lift the internal USB card to disconnect from the connector on the system board.
2. Remove the USB memory key from the internal USB card.
After working inside your
Safety
instructions.
Before working inside your
system.
System board jumpers and connectors
system.
Installing and removing system components
section.
85
Advertisement
Table of Contents
