Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Haier HC60BLX1
Summary of Contents for Haier HC60BLX1
- Page 1 Service Manual HC60BLX1 & HC90BLX1 Page 1 of 20...
-
Page 2: Table Of Contents
Contents Safety considerations and installation instruction ....................3 Safety ................................3 Installation instruction ............................. 3 Product code ................................3 Overall dimension ..............................4 Functions instructions ............................. 4 Usage ..................................5 Troubleshooting ............................... 6 Components replacement ............................7 Replace the LED light ............................7 Replace the switch ............................ -
Page 3: Safety Considerations And Installation Instruction
When the range hood is to be installed above a gas hob, the minimum distance between the hob and range hood must exceed 700mm (750mm is recommended). The height should be measured from the top of the burners. Product code MODEL EAN 13 HC60BLX1 50185 9415112501856 HC90BLX1 50186 9415112501863... -
Page 4: Overall Dimension
Overall dimension Ducting and ventilation: For best performance and lowest noise output, we recommend the use of 150mm. Functions instructions Control Panel Push the “0”button, and the motor will stop. Push the “1”button, and the motor will run at low speed. Push the “1”button, and the motor will run at mid speed. -
Page 5: Usage
Usage Important: do not perform maintenance or cleaning of the range hood without first switching off the electricity supply. Cleaning You should use a nonabrasive cleaner. Any abrasive cleaner (including Cif) will scratch the surface and could erase the control panel markings. You can clean your Range hood effectively by simply using a dilute solution of water and mild detergent and drying to a shine with a clean cloth. -
Page 6: Troubleshooting
Troubleshooting Fault phenomenon Fault cause Solution a. Power plug is not plugged in or a. Connect the power plug not plugged in properly b. Connect power or contact electrician No power b. Power socket has no power for service c. Power in not connected to the fuse c. -
Page 7: Components Replacement
Components replacement Replace the LED light (1) Turn off the cooker hood and remove the filters; (2) Use a screwdriver to remove the 2 screws on the lamp plate and remove the lamp plate; (3) Remove the terminal box from the inside of the body and disassemble; (4) Disassemble the terminal that needs to replace the lamp;... -
Page 8: Replace The Impeller And The Motor
Replace the impeller and the motor (1) Use a screwdriver to remove the 6 screws fixing the motor assembly and remove the motor assembly; (2) Remove the grease filters; (3) Replace the impeller: Use a screwdriver to remove the 5 screws on the volute and remove the left volute. -
Page 9: Electrical Principle Drawing
Electrical principle drawing Page 9 of 20... -
Page 10: Rating Label
Rating label Page 10 of 20...