Using The Led Light - Schumacher SL1582 Owner's Manual

NOTE:
lithium battery. If you hear only a click and the engine does not turn
With the jump starter connected to the car battery and the green LED
for one minute. This draws current from the jump starter and warms the
procedure. Extremely cold weather may require two or three battery
warmings before the engine will start.
NOTE:
IMPORTANT: DO NOT attempt to jump start your vehicle more
than three consecutive times. If the vehicle will not start after three
8.
in that order.
9. Recharge the unit as soon as possible after each use.
7.2 CHARGING A MOBILE DEVICE, USING THE USB PORTS
The unit includes two USB ports. One provides up to 2.4A at 5V DC;
9V at 2A or 12V at 1.5A.
1. Consult your mobile device manufacturer for proper charging power
2. Charging should begin automatically. The display will show which port
is in use.
3.
charging port used.
NOTE:
at a slower rate.
4.
your mobile device and then disconnect the charging cable from the unit.
5. Recharge the unit as soon as possible after each use.
NOTE:
automatically shut off after 30 seconds.

7.3 USING THE LED LIGHT

1. Hold down the display
2.
through the following modes:
• Steady glow
• Flash for an SOS signal
• Flash in strobe mode
3.
until the light turns off.
4. Recharge the unit as soon as possible after each use.
button for 2 seconds.
• 6 •
button to cycle
button