Table of Contents
Advertisement
3. Open the taps completely after making the
hose connection to check for water leaks at
the connection points. If any leaks occur, turn
off the tap and remove the nut. Retighten
the nut carefully after checking the seal. To
prevent water leakages and damages caused
by them, keep the taps closed when the
machine is not in use.
Connecting to the drain
•
The end of the drain hose must be directly
connected to the wastewater drain or to the
washbasin.
Your house will be flooded if the hose comes
A
out of its housing during water discharge.
Moreover, there is risk of scalding due to
high washing temperatures! To prevent such
situations and to ensure smooth water intake
and discharge of the machine, fix the end of
the discharge hose tightly so that it cannot
come out.
•
The hose should be attached to a height of at
least 40 cm, and 100 cm at most.
•
In case the hose is elevated after laying it on
the floor level or close to the ground (less than
40 cm above the ground), water discharge
becomes more difficult and the laundry may
come out excessively wet. Therefore, follow
the heights described in the figure.
•
To prevent flowing of dirty water back into the
machine and to allow for easy discharge, do
not immerse the hose end into the dirty water
or drive it in the drain more than 15 cm. If it is
too long, cut it short.
•
The end of the hose should not be bent, it
should not be stepped on and the hose must
not be pinched between the drain and the
machine.
•
If the length of the hose is too short, use it
by adding an original extension hose. Length
of the hose may not be longer than 3.2 m.
To avoid water leak failures, the connection
between the extension hose and the drain
hose of the product must be fitted well with
an appropriate clamp as not to come off and
leak.
Adjusting the feet
In order to ensure that the product operates
A
more silent and vibration-free, it must stand
level and balanced on its feet. Balance the
machine by adjusting the feet. Otherwise, the
product may move from its place and cause
crushing and vibration problems.
1. Loosen the lock nuts on the feet by hand.
2. Adjust the feet until the product stands level
and balanced.
3. Tighten all lock nuts again by hand.
Do not use any tools to loosen the lock nuts.
A
Otherwise, they will get damaged.
Electrical connection
Connect the product to a grounded outlet
protected by a fuse complying with the values in
the "Technical specifications" table. Our company
shall not be liable for any damages that will arise
when the product is used without grounding in
accordance with the local regulations.
•
Connection must comply with national
regulations.
•
Power cable plug must be within easy reach
after installation.
•
The voltage and allowed fuse or breaker
protection are specified in the "Technical
specifications" section. If the current value of
the fuse or breaker in the house is less than
16 Amps, have a qualified electrician install a
16 Amp fuse.
•
The specified voltage must be equal to your
mains voltage.
4
EN
Advertisement
Table of Contents
