The Standard Event Status Enable Register - HP 8153A Operating And Programming Manual

Example OUTPUT 722;">HCLS''
*ESE
standard Event Status Enable command.
Syntax *ESE <wsp> <value>
0 < value < 266
Definition The *ESE command sets bits in the Stai^dard Event Status
Enable register and thus enables the corresponding bits
in the Standard Event Status register. A 1 in a bit in the
enable register enables the same bit in the status register.
The value sent as an integer or a floating point number
{NRf).
The register is cleared at power-on. The *RST and *CLS
commands do not change the register.
Ihble 6-2.
The Standard Event Status Enable Register
BIT MNEMONIC Decimal
Value
7 Power On 128
6 Not used 0
5 Command Error 32
4 Execution Error 16
3 Device Dependent Error 8
2 Query Error 4
1 Not used 0
0 Operation Complete 1
Related Commands *ESE?
Example OUTPUT 722; "=kESE 21"
Remote Operation • Common Commands 6-5