Remove The Pogo Pin Fpc Cable R; Remove The Microphone Board - Lenovo 8APU1 Hardware Maintenance Manual

Remove the pogo pin FPC cable R

Make sure the following FRUs (or CRUs) have been removed.
"Remove the game controller" on page 26
"Remove the lower case" on page 28
"Disconnect the battery pack cable" on page 29
"Remove the LCD bracket" on page 30
"Remove the SSD cable holder graphite" on page 30
"Remove the solid-state drive (SSD)" on page 31
"Remove the speaker with antenna" on page 32
"Remove the battery pack bracket" on page 34
"Remove the fan" on page 35
"Remove the heat sink" on page 36
"Remove the audio board" on page 37
"Remove the system board and the system board cable" on page 39
"Remove the battery pack " on page 42
Step 1. Remove one screw and then remove the pogo pin FPC cable R.
Figure 29. Remove the pogo pin FPC cable R
Screw specifications
M1.6 x L3
Go to
https://support.lenovo.com/partslookup
replacement parts:
Pogo pin FPC cable R
Removable tape

Remove the microphone board

Make sure the following FRUs (or CRUs) have been removed.
Number of screws
1
to look up the Lenovo part numbers of the following
.
Chapter 4 Removing a FRU or CRU
43