Table of Contents
Advertisement
—_
Loading a User Program
. Press the [USER PROGRAM] button
The User Program screen (see above) is displayed.
. Use the buttons to the side of the display to select a User
Program memory.
* Choosing <Manual> changes the panel settings to the
ones in effect before the User Program was called up.
¢ You can also decide when the settings relating to the
Arranger are loaded. See "User Program Arranger
Update" on page 50.
Naming (or renaming) a User Pro-
gram
Here is how to name or rename a User Program:
. On the User Program screen, hold down the [USER PRO-
GRAM] button and select a User Program memory.
oe
USER PROGRAM
RENAME +--+
[Jazz
Band
]
. Use <> and <P> below the display and <A>and <¥> to
the left of the display to enter the name.
See page 32 fora
list of available characters.
. Press <Execute>.
Saving User Programs to disk
You can store up to 32 User Programs, including
Manual settings, on the KR-75. These 32 User Pro-
grams make up one set, and up to 99 sets can be
saved on a disk.
User Programs can only be saved on a disk that has
been formatted by the KR-75 or an E-300/ 500. If
you're using a new disk, first format it (see page
35), then carry out the following steps.
. Set the Write Protect tab on the disk to the "Write" position
and insert the disk into the disk drive.
. Press the [USER PROGRAM] button.
The User Program screen is displayed.
. Press <Disk...>.
weer
Yeer
Program
Save/Load
~~
a~
[KR_ea1
]
. Use <A> and <¥> to the right of the display to select a
number.
You can choose any number between "1" and "99".
Do note, however, that selecting a User Program
number that already contains data means that the
User Program Set (i.e. 32 precious User Programs)
in question will be overwritten by your new set.
5. Use <€> and <>> below the display and <A> and <¥> to
the left of the display to enter a name.
See page 32 for a list of available characters.
6. Press <Save> at the bottom right of the display.
* To cancel without saving the User Program Set, press
the [EXIT] button.
Loading a User Program set from
disk
_
into the disk drive.
2. Press the [USER PROGRAM] button.
The User Program screen is displayed.
3. Press <Disk...>.
4. Use <A> and <¥> on the right of the display to choose the
User Program.
5. Press <Load> at the bottom right of the display.
° Please bear in mind that loading a User Program set
means that all 32 internal User Program memories will
be overwritten. You may want to save them to disk first
(see above).
* To stop the operation, press the [EXIT] button,
11.2. Pad buttons: additional or
frequently used functions
You can assign a wide variety of performance-relat-
ed functions to the two PAD buttons on the panel.
After a function has been assigned, it can be called
up by pressing the corresponding PAD button.
O
oO
To Variation
To Original
Pad
FH in
1. On the Basic screen, press <Pad/Pedal>.
AS
Lt Pad i
2. Use <A> and <¥> next to the display to assign a function to
"Pad 1" and "Pad 2."
* Press [EXIT] if you've changed your mind about
assigning one of the following functions to a PAD but-
fon.
45
. Insert the floppy disk that contains the desired User Program
m
<
i)
am
n
x
Advertisement
Table of Contents
