Advertisement
5. Check the image
1.
Turn on the controller and the mobile device, then check the image of main gimbal
with Airpeak Flight. Make sure that there is no oscillation on the screen. When using
the camera in a downward orientation, make sure on Airpeak Flight that the image is
not shaking while pointing in that direction. Especially when the ROLL axis is facing
downward, shaking is likely to occur. If oscillation occurs, identify which axis is vibrating
by decreasing axis value of each axis around 20 in BASIC setting of gTuneDesktop.
Once you find the vibrating axis, adjust the value by around 5 to 10, then re-check the
image on Airpeak Flight.
If the image is still vibrating, turn off the aircraft and double check that the balance of
the gimbal is properly adjusted.
2.
Pull out the microUSB cable and turn off the aircraft. Re-connect the control cable
which you disconnected in "Connect gimbal to PC" section.
Advertisement
