Invertec 275Tp - Side Panels Removal - Lincoln Electric INVERTEC 300 TP Service Manual

®
INVERTEC 300TP - SIDE PANELS REMOVAL
A
A
Bottom view
Procedure:
1. Turn ON/OFF switch to OFF position.
2. Disconnect Input Power from the machine !
3. Using the TORX wrench TX-25 driver, remove the 4 screws (A) on the bottom of machine
4. Remove the two side panels sliding them downward, taking care to disconnect the two ground wires
connected to each panel.
5. Follow the next page for DC BUS capacitors discharge procedure!