Disassembly Operations - Lincoln Electric INVERTEC 300 TP Service Manual

Figure 16
REMOVAL PROCEDURE
Necessary tool:
- Screwdriver type PH02
- Torx 25 wrench
1. Remove main input power to the INVERTEC
2. Perform the Case Removal and Discharge procedure
3. Locate the two screws (A). See Figure 16
4. Using screwdriver PH02 remove them and remove the red plastic insert.
5. Using the screwdriver PH02 remove the screw (B) that is fixing the metal handle. See Figure 17
6. Using the Torx 25 wrench remove the two screws (C). See Figure 17
7. Using the Torx 25 wrench remove the two screws (D). See Figure 18
8. Pull gently the rear plastic panel and remove it from the machine.
9. Slide to the backside the upper panel being careful to disconnect the earth wire.
10. For the re-assembly operations, make the previous steps in the reverse order

DISASSEMBLY OPERATIONS

UPPER AND REAR PLASTIC PANEL REMOVAL PROCEDURE
A
D
Figure 18
®
300 TP.
WARNING
Disconnect input power before servicing.
Do not operate with covers removed.
Do not touch electrically live parts.
Only qualified persons should install, use
ELECTRIC SHOCK
or service this equipment.
CAN KILL
B
C
Figure 17