Smeg DWD612SS Instruction Manual page 9

User instructions
START PROGRAM
To start the appliance, simply press the START/PAUSE button (5) for a few seconds, the
PROGRAM PHASES lights (10) will go out until the light of the first phase of the selected program
start flashing (confirmation buzzer). This phase, that updates itself during the cycle, is "indicative"
since it is influenced by the washing conditions such as dishwasher type and quantity, entry
temperature etc.
At this point the PROGRAM PHASES lights (10) will illuminate as the program progresses,
indicating the point reached in the washing procedure:
Prewash
Wash
Rinse
END PROGRAM
When the program finishes, a buzzer sounds briefly and all the
PROGRAM PHASES lights (10) flash. Press any of the SELECTION
PROGRAMS buttons (2), stops the light flashins, and the
dishwasher is now ready to perform a new cycle; opening and
shutting the door or switching the appliance off and on has the same
effect.
INTERRUPTION OF A PROGRAM
In order to interrupt a running program it is necessary:
•
press the START/PAUSE button (5), the light of the current phase goes out;
• keep the button pressed until the PROGRAM PHASES lights (10) come on (confirmation
buzzer).
TO CHANGE A PROGRAM
To change the running program it is necessary:
•
to interrupt the running program (see "I
• select the new program;
•
to press again the START/PAUSE button (5) to make start the new program.
ANNULLING A PROGRAM
To annul the program in progress, it must first be interrupted (see "I
Dry
The light of the phase in progress will flash, and will remain
constantly on while heating is in progress.
NTERRUPTION OF A PROGRAM
Now press buttons P1+P2 simultaneously and the first three program
lights will come on.
");
NTERRUPTION OF A PROGRAM
").
31