Washing Programs - Smeg DWD612SS Instruction Manual

In case that the door is opened during the operation, to the next door closing it is going to be
necessary to start the program as shown in paragraph " S
from the point in which it was interrupted.
In case that the tub temperature is higher than 50°C the program will start about 30 seconds
later.
3.2
The dishwasher is equipped with a control panel, described in chapter "3. Description of the
controls", from which it is possible to carry out all the power switch-on, switch-off and programming
operations.
Before starting a washing program make sure that:
•
•
•
•
•
HALF LOAD WASH FUNCTION (on some models only)
Pressing button ½ LOAD WASH (4) selects washing on the top basket only.
After selecting the program, proceed as follows:
•
•
The ½ LOAD wash option can be selected in all programs except the soak program.
N.B.: selecting the ½ LOAD option changes the duration of the program.
It is possible to place a cutlery basket inside the basket selected for the HALF-LOAD program; the
other basket must remain empty.
WARNING: do not load dishes and cutlery into the non-selected basket, because the water
spray will only reach the selected basket.
DELAY PROGRAM (on some models only)
Pressing button DELAY PROGRAM (3) in sequence delays the start of the program by 3, 6 or 9
hours. This allows you to set the dishwasher to work at specific times of day.
After selecting the delay, start the program in the normal way (see relative section).
The appliance will prewash the dishes, after which the "delay program" set previously will come into
effect (the phase lights switch off and the light relating to the delay set flashes).
To reset or change the delay once the program has started:
•
•
•
32
User instructions

Washing programs

The water supply tap is open.
The correct amount of detergent has been added to the dispenser .
The baskets have been correctly loaded.
The spray arms are able to rotate freely and without obstruction.
The dishwasher door is securely closed .
press the button ½ LOAD WASH (4) once to select the top basket (the relative light comes on);
press the button ½ LOAD WASH (4) again to return to full load wash status (the light goes
out).
press the START/PAUSE button (5) for a few seconds, until the PROGRAM PHASES lights
(10) come on;
press the DELAY PROGRAM button (3) several times "until the program delay" returns to zero
(all the lights indicating the delay go out);
press the START/PAUSE button (5) to start the new program.
". The program will resume
TART PROGRAM