Advertisement
6. Troubleshooting
The dishwasher is equipped with a self-diagnostics system that is
capable of detecting and signalling a number of possible faults.
In the event of a fault or malfunction, before calling the After-sales
service centre, we suggest that you first consult the troubleshooting
guide below.
If the problem persists even after implementing the recommended
solutions, call the After-sales service centre after having carried out the
following:
•
making a note of the message displayed by the self-diagnostics
system;
•
unplug the power cord from the socket;
•
shut off the water supply tap.
TABLE OF FAULTS DETECTED BY THE SELF-DIAGNOSTICS SYSTEM
FAULT
The system which limits the water level inside the dishwasher
(Level Safety Device) has been tripped.
E2
Since the cause might be a temporary failure, try reprogramming the
dishwasher. If the problem persists, call the authorised technical service
centre.
The dishwasher fails to heat the water.
To reset the appliance, open and close the door.
E3
To determine the cause of this problem call the authorised technical
service centre.
The temperature monitoring system has failed.
E4
Switch the dishwasher off, switch it back on and restart the washing
program. If the alarm recurs, call the After Sales Service.
The dishwasher fails to draw water.
Check that:
•
the water supply tap is open;
E5
•
the filter in the water intake hose is not clogged;
•
the water intake hose is not kinked or bent.
Switch the dishwasher off and back on. If the problem is resolved the
washing program will resume from where it was halted.
If the fault persists, call the authorised technical service centre.
60
User instructions
DESCRIPTION
Advertisement
Troubleshooting
