Digital Recording Of A Digital Source On The Dat; Recording Radio Broadcast (With The Tuner) - Kenwood DA-9010 Instruction Manual

corvoP 1
DAT oOBS/voP 2
[ ANALOG ]
REC OUT
anacog TISTAL ruven
TAPE 1 2 OFF
TAPE 21
co/voP 1
ae DBS/VOP 2
TAPE 2
VIDEO TUNER
PHONO
Set to TUNER
@ Digital recording of a digital source on the DAT
(CD/VDP1, DBS/VDP2)
1. Press the DIGITAL switch.
2. Set the DIGITAL Input selector switch to CD/VDP1 or
DBS/VDP2.
3. Play the source component connected to the input se-
lected in step 2.
4. Put the DAT recorder in the Record mode.
Note:
When the ditital recording operation is to be performed while you
are listening to an analog source, ensure that the DAC switch on
the rear panel is set to UNSWITCHED.
@ Recording radio broadcast (with the tuner)
. Press the ANALOG switch.
. Set the ANALOG input selector to the TUNER position.
. Set the REC OUT selector to the TUNER position.
. Operate the tape deck, DAT deck or VCR to set to the
record mode.
. Operate the tuner (to tune to the desired broadcast
station).
6. Adjust the recording level with the Record Level control
on the tape deck (or DAT deck, VCR).
PWN =
oa
When the REC OUT selector switch is in the OFF position
REC OUT
anacos COSTAL tuner
TAPE 1 2 OFF
TAPE 21
In this position, no signal is output from the TAPE1/DAT
and TAPE2/VIDEO jacks on the rear panel. With this set-
ting, all of the tape deck connections are cut. Thus, this am-
plifier will not be affected by the impedance from the tape
decks, and the source sound can be enjoyed with superior
quality without interference or induction noise.
DA-9010 ts) 13