Table of Contents
Advertisement
MANUAL TUNING
cr..FM..T^AMi
2 Press the UP A or DOWNV button to select a
station.
DIRECT TUNING
1 Press the TUNER button to select a band.
2 Press the TUNER button and hold it down until
"flashes on the display (DirectTuning Mode).
3 Press the appropriate numbered buttons to tune
in to the desired station.
To tune in to 106.50 MHz, press 1,0, 6, 5 and 0 buttons.
To tune in to 95.20 MHz, press 9, 5, 2 and 0 buttons.
To cancel the Direct tuning mode
•When entering a frequency out of tuning range, the value;
flashes for two seconds and then goes off. Check the frequency
and repeat step 3 correctly.
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation
system is 9 kHz/step, change the tuning interval.
Hold down the TUNER button and press the POWER button
immediately. Note that the unit is set to the Direct Tuning mode
if the TUNER button is pressed and held down for about half
a second.
1 1 ENGLISH
Advertisement
Table of Contents
