Radio Reception; Manual Tuning - Aiwa AV-D67 Operating Instructions Manual

RADIO RECEPTION

MANUAL TUNING

1 Turn the FUNCTION to select the TUNER function,
and press the DIGITAL/ANALOG/BAND button
repeatedly to select the desired band.
The display changes to frequency indications after indicating
band and video source (V1, V2 or V3) for two seconds.
2 Press the N or M button to select a station.
Each time the button is pressed, the frequency changes.
When a station is received, "TUNE" is displayed for two
seconds. During FM stereo reception, 1 is displayed.
When operating with the remote control
Press the TUNER/BAND button while pressing the SHIFT button
in step 1, and the TUNING DOWN or UP button while pressing
the SHIFT button in step 2.
To search for a station quickly (Auto Search)
Keep the N or M button pressed until the tuner starts
searching for a station. After tuning in to a station, the search
stops.
To stop the Auto Search manually, press the N or M button.
When operating with the remote control, keep the TUNING UP
or DOWN button pressed while pressing the SHIFT button.
• The Auto Search may not stop at stations with very weak
signals.
When an FM stereo broadcast contains noise
Press the MONO TUNER button while pressing the SHIFT button
on the remote control so that "MONO" appears on the display.
Noise is reduced, although reception is monaural.
To restore stereo reception, repeat the above so that "STEREO"
appears.
13
ENGLISH
When the reception contains noise interference
Move the unit away from other electrical appliances, especially
digital audio devices, or turn off the appliances that generate
noise signals.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation
system is 9 kHz/step, change the tuning interval.
Hold down the DIGITAL/ANALOG/BAND button and press the
POWER button.
To reset the interval, repeat this procedure.