Advertisement
User instructions
INTERRUPTING A PROGRAM
To interrupt a program, press the START/PAUSE key (F) and keep it
pressed until "In pause" appears on the bottom line of the DISPLAY (G).
To restart the program, repeat this operation until "Duration XX min"
reappears on the bottom line of the display.
Opening the door only cuts out the program in progress, but this is not
recommended, since water splashes or gusts of steam might escape.
When the door is closed the program restarts automatically, even it
was interrupted by pressing the START/PAUSE key (F).
CHANGING THE PROGRAM (standard programming)
To change a program while it is running, proceed as follows:
•
press key (F) to set the program in pause status;
•
open the door and select the new program using key (B);
•
close the door; the changes relating to the new program will
appear on the DISPLAY (G).
CHANGING THE PROGRAM (assisted programming)
•
To change a program while it is running, the appliance must be
reprogrammed, or
•
Switch the appliance off and back on to access the normal
programming mode.
15
Advertisement
