Smeg DI614H Instruction Manual
  1. Manuals
  2. Brands
  3. Smeg Manuals
  4. Dishwasher
  5. DI614H
  6. Instruction manual
Smeg DI614H Instruction Manual

Smeg DI614H Instruction Manual

Smeg dishwasher instruction manual
Hide thumbs Also See for DI614H:
Table of Contents

Advertisement

Quick Links

EN
INSTRUCTION MANUAL
GUIDE FOR USING THE DISHWASHER AND THE WASHING PROGRAM

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DI614H and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Smeg DI614H

Summary of Contents for Smeg DI614H

  • Page 1 INSTRUCTION MANUAL GUIDE FOR USING THE DISHWASHER AND THE WASHING PROGRAM...

  • Page 4: Safety Instructions

    THAT OPENINGS UNDERSIDE OBSTRUCTED. ALWAYS SWITCH OFF THE DISHWASHER AFTER EACH USE TO AVOID WASTING ELECTRICITY. OBSOLETE APPLIANCES MUST BE RENDERED UNUSABLE. CUT OFF THE MAINS POWER CORD AFTER UNPLUGGING IT FROM THE WALL OUTLET, AND MAKE SAFE ANY COMPONENTS WHICH MIGHT BE DANGEROUS FOR...
  • Page 5 OFFICE, YOUR HOUSEHOLD WASTE DISPOSAL SERVICE OR THE SHOP WHERE YOU PURCHASED THE PRODUCT. IN THE EVENT OF A FAULT, DISCONNECT THE DISHWASHER FROM THE ELECTRICAL POWER SUPPLY AND SHUT OFF THE WATER TAP. DO NOT USE APPLIANCES WHICH HAVE BEEN DAMAGED DURING TRANSIT! IF IN DOUBT, CONSULT YOUR DEALER.
  • Page 6 DO NOT DRINK THE WATER RESIDUES WHICH MAY BE PRESENT INSIDE THE DISHES OR DISHWASHER AT THE END OF THE WASHING PROGRAM AND BEFORE THE DRYING CYCLE. KNIVES OR OTHER SHARP-ENDED COOKING UTENSILS MUST BE PLACED IN THE CUTLERY BASKET BLADE-DOWN, OR LAID HORIZONTAL IN THE TOP BASKET.

  • Page 7: Installation Instructions

    Position the appliance in the desired place of installation. The back or sides of the dishwasher may be placed up against walls or other furniture units. If the dishwasher is installed near a heat source, fit the special insulating panel to prevent overheating and malfunction of the appliance.

  • Page 8: Connecting To Water Supply

    The dishwasher can also be connected to a hot water supply not exceeding 60°C. Supplying the appliance with hot water cuts down the washing time by approximately 20 minutes, but slightly reduces its effectiveness.
  • Page 9 Installation instructions 2.2 Electrical connection and precautions CHECK THAT THE VOLTAGE AND THE FREQUENCY OF THE MAINS MATCH THE RATINGS ON THE NAME PLATE OF THE APPLIANCE POSITIONED ON THE INNER EDGE OF THE DOOR. THE PLUG ON THE SUPPLY CORD AND THE CORRESPONDING SOCKET OUTLET MUST BE OF THE SAME TYPE AND MEET THE REGULATIONS IN FORCE.
  • Page 10 Installation instructions WHEN CLEANING AND MAINTAINING THE APPLIANCE: BEFORE CARRYING OUT ANY WORK, ALWAYS UNPLUG THE APPLIANCE FROM THE ELECTRICAL SUPPLY OR SWITCH OFF THE ALL-POLE DISCONNECTION DEVICE. FOR GREAT BRITAIN ONLY: THIS APPLIANCE MUST BE EARTHED. Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A.S.T.A.

  • Page 11: Instructions For The User

    Instructions for the User 3. BEFORE USING AND SETTING UP YOUR APPLIANCE The electronic control system allows you to customise your appliance in a number of ways. Use button (D) to select the customisation you require, then button (E) to enable (1) / disable (0) or modify the parameters. To exit the programming function press button (B).
  • Page 12 Instructions for the User 3.2 Water hardness Select the water hardness customisation function using button (D). Press (E) in repetition to select the hardness level required (from H0 to H5) with reference to the “WATER HARDNESS TABLE”. WATER HARDNESS TABLE German degrees (°dH) 5 - 15 16 - 23...
  • Page 13 N.B.: the functions of buttons (C) and (F) are the same. 4.2 The information display The dishwasher is fitted with a convenient sloping display (G) to assure good visibility from both in front and above. The display uses brief text messages...

  • Page 14: Starting The Programme

    “Buzzer enabled” function is on (see “SETTING UP YOUR APPLIANCE”) It is possible to select the programme on your dishwasher in 2 ways: 1. Rapid programming selection 2. Manual programming selection...
  • Page 15 Instructions for the User Shown on the display: • Press (D) or (E) to select rapid programming (see “Rapid programming”). • Press (B) to exit rapid programming and choose standard programming (see “Standard programming”). 5.3 Rapid programming • Press on/off button (A) to switch machine on. •...
  • Page 16 If the dishwasher door is open or not properly closed, the washing cycle will not start If the door is opened with the dishwasher in operation, a long buzzer sounds and “Pause” appears on the bottom line of the DISPLAY (G). Next time the door is closed the programme will continue from where it stopped.

  • Page 17: Programme Table

    The options are available in all programmes except the soak programme. (*) Reference programme for EN 50242 standard. (**) See display. (***)When the "AUTO 40-50” or “AUTO 60-70” programme is selected, the dishwasher recognises the type of dirt and automatically adapts the washing parameters and washing stages as appropriate.

  • Page 18: Interrupting A Programme

    Instructions for the User 7. SPECIAL PROGRAMME FEATURES The top line displays the temperature in the tank, alternating (every 4 seconds) with the programme being performed and the current programme stage. The bottom line will show the programme duration “Duration XX minutes”, where XX is the time left before the end of the programme, in minutes.

  • Page 19: Changing The Programme

    • close the door. “Empty tank” will appear on the DISPLAY (G) and the dishwasher will start to pump out the water. This will be completed in about 1 minute and “Progr. End” will appear on the top line of the display.
  • Page 20 Shown on DISPLAY (G): "Delayed Hours 0, 1, ...12/24”. The start of the washing programme can be set with a delay from 1 to 12/24 hours. This function allows you to set the dishwasher to work at your preferred time of day and avoid having several appliances (washing machine, oven, etc.) in operation simultaneously.
  • Page 21 "3 in 1" or "triple action" products. In this case the dishwasher will make the most effective use of the product, not using any salt or rinse aid which the appliance may contain.
  • Page 22 If the temperature falls while the hygene rinse is in progress (e.g. due to a power blackout or because the door is opened), the DISPLAY (G) flashes until the dishwasher is switched off or a new programme is set, to warn that the option has not been carried out.

  • Page 23: User Instructions

    Before replacing the cap, remove any salt residues from around the opening. • When using the dishwasher for the first time, in addition to the salt it is also necessary to add one litre of water to the container. •...
  • Page 24 • Do not use table salt as it contains insoluble substances which, over time, may damage the water softening system. • When necessary, refill the regenerating salt container before starting the washing program. In this way, the excess saline solution will be immediately removed by the water; the prolonged presence of salt water inside the tank may lead to corrosion.

  • Page 25: Adding The Rinse Aid

    ADJUSTING THE RINSE AID DISPENSER SETTING The dishwasher is factory set for medium water hardness. However it possible to change the setting by turning the dispenser’s selector to the desired position: the amount of rinse aid dispensed is proportional to the selector position.
  • Page 26 • Do not use detergents formulated for washing dishes by hand, because they produce a great deal of foam and may negatively affect the operation of the dishwasher. • Add the correct amount of detergent. An insufficient amount of detergent will result in a partial removal of dirt from the dishes, whereas an excessive amount is wasteful and does not improve the washing results.
  • Page 27 "3/1" Products If you wish to use detergents which already contain salt and rinse aid, check whether your dishwasher is fitted with the "3/1 option button" on the "Controls description" page and then refer to the section which explains how to use this function.
  • Page 28 9.3 General warnings and recommendations Before using the dishwasher for the first time, it is advisable to read the following recommendations concerning dish types to be washed and their loading. There are generally no constraints on the washing of domestic dishes, but in certain cases it is necessary to take their characteristics into account.
  • Page 29 • Glass and crystal: in general, glass and crystal objects can be washed in the dishwasher. However, certain types of glass and crystal may become dull and lose their clearness after many washings. Therefore, for these items we recommend using the least aggressive program available.

  • Page 30: Lower Basket

    User instructions 9.4 Using the baskets The dishwasher has a capacity of 14 place-settings, including serving dishes. EN 50242 STANDARD LOADS FOR CERTIFICATION BODIES LOWER BASKET UPPER BASKET EN 50242 cycle test conditions: Lower basket: the grid "A" ("lower basket" section) must not be raised.

  • Page 31: Loading The Lower Basket

    In the front there are one or two supports (depending on the models) for small plates (B). To use them, they have to be turned towards the front of the dishwasher. LOADING THE LOWER BASKET Carefully load flat plates, soup plates, dessert and serving dishes, positioning them vertically.

  • Page 32: Cutlery Basket

    User instructions CUTLERY BASKET Cutlery must be placed with the tips facing downward. Long items of cutlery (ladles, wooden spoons, kitchen knives, etc.), which might interfere with the upper spray arm must be placed in the upper basket, ensuring that knife tips do not project from the basket. The cutlery basket features an exclusive system of independent sliding tip-up supports, offering a series of combinations to allow optimum use of the space available.

  • Page 33: Loading The Upper Basket

    User instructions UPPER BASKET It is recommended to load the upper basket with small- or medium-sized items such as glasses, small plates, tea or coffee cups, shallow bowls and light objects made from heat resistant plastic. If the upper basket is used in the lowermost position, it can also be loaded with serving dishes, provided they are only slightly soiled.

  • Page 34: Adjusting The Upper Basket

    ADJUSTING THE UPPER BASKET The upper basket can be adjusted in two positions, according to the user’s needs and according to the height of the dishes in the lower basket. Proceed as follows. • pull out the basket to its limit position and pull the right side upwards.

  • Page 35: Cleaning The Water Intake Filter

    10.1 General warnings and recommendations Avoid the use of acidic or abrasive detergents. Clean the outer surfaces and door-lining of the dishwasher regularly using a soft cloth moistened with water or with a normal detergent suitable for painted surfaces. Clean the door gaskets with a damp sponge.

  • Page 36: Cleaning The Filter Unit

    The filters should be cleaned under running water using a stiff brush. • It is essential to thoroughly clean the filters according to the above instructions: the dishwasher cannot function if the filters are clogged. • Carefully replace the filters in their seats, to avoid damaging the wash pump.

  • Page 37: Troubleshooting Minor Problems

    In some cases it is possible to remedy minor problems by referring to the following instructions: If the program fails to start, check that: • the dishwasher is connected to the electrical power supply; • there is no power failure; •...
  • Page 38 If the dishes fail to dry or remain dull, check that: • there is rinse aid inside the special container; • the rinse aid dispenser setting is correct; • the detergent used is of good quality and has not lost its effectiveness (for example, through incorrect storage, with the box left open).
  • Page 39 The system is tripped in case of water leaks. Contact the after-sales service. Safety device tripped The system which limits the water level inside the dishwasher has been tripped. Interrupt the programme and switch off the dishwasher. Switch the dishwasher back on, programme it again and start the washing cycle.
  • Page 40 The appliance is not able to "measure" the amount of water loaded accurately. Interrupt the programme and switch off the dishwasher. Switch the dishwasher back on, programme it again and start the washing cycle. If the problem persists, contact the after-sales service.
  • Page 41 TECHNICAL DATA Width Depth measured flush with the outer edge of the control panel Height (depending on models) from 820 mm to 870 mm Capacity Water supply pressure Electrical characteristics User instructions 597 ÷ 599 mm 550 mm from 860 mm to 910 mm 12 Standard place settings min.
  • Page 44 19 590 1216 02...

This manual is also suitable for:

Di614

Table of Contents