Related Manuals for Rinnai RE Series
Summary of Contents for Rinnai RE Series
- Page 1 ●...
- Page 2 This conversion kit shall be installed by a qualified service agency in accordance WARNING with the manufacturer’s instructions and all applicable codes and requirements of the authority having jurisdiction. The information in these instructions must be followed to minimize the risk of fire or explosion or to prevent property damage, personal injury or death.
- Page 3 For installations in Canada, the conversion shall be carried out in accordance with the requirements of the provincial authorities having jurisdiction and in accordance with the requirements of the CGA- B149.1, Natural Gas and Propane Installation Code. The appliance must be installed in accordance with: •...
- Page 4 Model RE199 RE180 RE160 RE140 REP199 REP160 Minimum 10,400 10,400 10,400 10,400 Gas Consumption (Btu/h) Maximum 199,000 180,000 160,000 140,000 Minimum: 4.0 in. (1.00 kPa) W.C. Natural Gas Maximum: 10.5 in. (2.61 kPa) W.C. Gas Supply Pressure Minimum: 8.0 in. (1.99 kPa) W.C. Propane Maximum: 13.0 in.
- Page 5 1. Remove front panel from water heater. 8. Remove the 5 screws around the pe- 2. Turn off the gas. rimeter of the existing gas manifold (Figure 4). 3. Disconnect the electrical power. 4. Remove the screw securing the controller and controller mounting plate to the water heater (Figure 1).
- Page 6 11. Disconnect the solenoid wires from all four gas 16. Secure the gas manifold to the gas solenoids (Figure 7). control valve with two hex head screws (Figure 10). Yellow/Black Orange/Black Figure 10 Blue/Black Red/Black Be careful not to tear or NOTICE Figure 7 pinch wires between...
- Page 7 IMPORTANT • Confirm that the inlet gas pressure is between the minimum and maximum pressures allowed for this appliance. CAUTION • Do not touch any other areas on the PC board other than the described buttons while power is supplied to the appliance. Parts of the PC board are supplied with 120 VAC. •...
- Page 8 Complete this section for high altitude installation or after converting for gas type. Confirm that the inlet gas pressure is between the minimum and maximum pressures allowed for this appliance. 7. Turn on the gas supply. CAUTION 8. Flow water through the water heater at Do not touch any other areas on the PC board the maximum flow rate obtainable.
- Page 9 Read the section “For Your Safety Read Before Operating” in section “4.4 WARNING Operating Instructions” before starting the steps below. 1. Press the “On/Off” button on the controller to start the unit. The LED display will illuminate, the combustion fan will begin to run if water is flowing, and the spark will ignite the main burner. 2.
-
Page 10: For Your Safety Read Before Operating
The following operating information is required by ANSI Z21.10.3 FOR YOUR SAFETY READ BEFORE OPERATING If you do not follow these instructions exactly, a fire or WARNING explosion may result causing property damage, personal injury or loss of life. A. This appliance does not have a pilot. •... - Page 11 100000784(01) 6/2022...