Smeg D4W Manual For Using page 14

User instructions
TO CHANGE A PROGRAM
To change the running program it is necessary:
•
to interrupt the running program (see "I
•
select the new program;
•
to press again the START/PAUSE button (3) to make start the new
program.
ANNULLING A PROGRAM
To annul the program in progress, it must first be interrupted (see
"I
NTERRUPTION OF A PROGRAM
In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph "S
TART PROGRAM
which it was interrupted.
In case that the tub temperature is higher than 50°C the program
will start about 30 seconds later.
The washing cycle will not take place if the dishwasher door is left open
or not properly closed.
TO SAVE ON ENERGY! ... AND PROTECT THE ENVIRONMENT
•
Always try to run the dishwasher fully loaded.
•
Do not wash the dishes in running water.
•
Use the washing program that is most appropriate for each type of
load.
").
Now press buttons P1+P2 simultaneously and
the first three program lights will come on.
". The program will resume from the point in
NTERRUPTION OF A PROGRAM
");
13