Table of Contents
Advertisement
[ Broadcasting station identification
By associating a name with a certain broadcasting station it is possible to avoid
having to remember, each time, in which channel number that particular station has
been memorized.
Five different characters are available for station identification.
By using PROGR
+ or -, or the
The programme number
to be set for
number keys of (4) OO®
identification appears on
the remote
OOO
the screen.
control unit,
O@O®
select the
(=) B®
programme
number to be set
for identification.
The number flashes on
the screen.
Press >
The first indication line
flashes on the screen.
Using the
+
or — buttons select — FS +
a letter of the
alphabet, a
number, or a
blank space.
Alphabet letters,
numbers or a blank
space ("'-") appear on
the screen, in that order.
in this way the first
character has been set,
and the following
position now flashes on
the screen.
All indications under the
og } Programme number
disappear from the
screen. All indications
remaining on the screen
have been memorized.
| Manual fine tuning
If the picture is not p
Operation
Press (8) + of — repeatedly uniil the picture
is at the optimum.
:
Press -D to start preselection.
The programme number starts flashing on
the screen.
TIEN V.
Manual fine tuning fas been memorized.
Note:
Manual fine tuning will be reset when the channel is selected again.
tect, it is possible to fine tune it manually.
The indication --F — appears on the screen.
1-4.
USE OF THE TELETEXT
SERVICE
Through the teletext service a great deal of information can be received at any time.
Broadcasting stations make this service available through TV broadcasts. To use the
teletext service, use the green keys on the "complete" side of the remote control unit.
When the "simple" side of the remote control unit is used, only the basic functions
are available.
| How to display teletext service
Operation
The channel changes on the screen.
watch,
a
Press @
1
Select the channel you want to
If there is no
teletext signal, the
indication "Page
100" appears on
the screen.
it
The selected page number appears
on the screen. After a few seconds,
the selected page appears on the
screen.
Use the number keys of the
remote control unit to insert the
three figures corresponding to
the desired teletext page.
Note
In case of a mistake, press any
three numbers, and then repeat
the operation with the correct
'numbers,
To revert to normal TV programmes:
Press ©.
To change teletext channel:
First press © to revert to the TV mode, and then repeat procedure steps
1 to 3.
Note: A weak TV signal may cause troubles in the use of teletext.
[ Use of special teletext functions
Required function
Operation
Result (on the screen)
Page index required.
Press ®
(INDEX).
Page index
appears.
Sub-pages required (page 888). | Press O
The sub-page
appears
|
(page 888).
Access to previous or following
Press @ (PAGE +) or
The preceding
Pages.
© (PAGE -).
or the following
Gage appears.
Advertisement
Table of Contents
