Table of Contents
Advertisement
en Rapid heating
When the operation has ended, remove the food
9.
from the cooking compartment. The appliance auto-
matically switches off completely after approximately
15 to 20 minutes.
Rapid heating
9 Rapid heating
To save time, rapid heating
ing time for set temperatures over 100 °C.
Rapid heating is possible for the following types of
heating:
¡ 4D hot air
¡ Top/bottom heating
¡ Intensive heat
9.1 Setting rapid heating
To ensure an even cooking result, do not place the
food in the cooking compartment until rapid heating
has come to an end.
Note: Do not set a cooking time until rapid heating has
come to an end.
Time-setting options
10 Time-setting options
For an operation, you can set the cooking time and the
time at which the operation should be finished. The
timer runs independently of the operation.
Time-setting
Use
option
Cooking time
If you set a cooking time, the appli-
ance stops heating automatically
once this time has elapsed.
End time
Along with the cooking time, you can
set the time at which you want the
operation to end. The appliance
starts up automatically so that the
operation finishes at the required
time.
Timer
You can set the timer to run inde-
pendently of the appliance during op-
eration. It does not affect the appli-
ance.
10.1 Setting the cooking time
You can set the cooking time for the operation of up to
24 hours.
Requirement: An operating mode and temperature or
setting have been set.
Press "Cooking time".
1.
To set the cooking time, press the relevant time
2.
value, e.g. hour display "h" or minute display "min."
a The selected value is marked in blue.
Set the cooking time using the adjustment line or
3.
enter it directly via the number field
If required, use
to reset the adjustment value.
Use "Start" to start the operation.
4.
a The appliance starts to heat and the time counts
down.
16
can shorten the preheat-
.
Note: If required, change the different basic settings
again.
Set a suitable type of heating and a temperature of
1.
at least 100 °C.
Rapid heating automatically switches on at temper-
atures of 200 °C and above.
Press "Rapid heating".
2.
a "On" is in the tile.
Press "Start" to start the operation.
3.
a Rapid heating starts.
a Once rapid heating has ended, a signal sounds.
"Off" appears for "Rapid heating"
Place the food in the cooking compartment.
4.
Cancelling rapid heating
Press "Rapid heating".
▶
a For "Rapid heating"
a Once the cooking time has elapsed, a signal tone
sounds. A note appears on the display confirming
that the operation has finished.
Once the cooking time has elapsed:
5.
If required, you can select other settings and re-
‒
start the operation.
When the food is ready, use
‒
pliance off.
Changing the cooking time
You can change the cooking time at any time.
Press the cooking time.
1.
Change the cooking time using the adjustment line
2.
or enter it directly via the number field
Press "Apply".
3.
Cancelling the cooking time
You can cancel the cooking time at any time.
Press the cooking time.
1.
Reset the cooking time using
2.
Note: For operating modes that always require a
cooking time, the appliance resets the cooking time
to the preset value.
Press "Apply".
3.
10.2 Setting the end time
You can delay the time at which the cooking time for
the operation is due to end by up to 24 hours.
Requirements
¡ An operating mode and temperature or level have
been set.
¡ A cooking time is set.
Press "End time".
1.
Delay the time using the adjustment line or directly
2.
via the number field
If required, use
to reset the setting value.
.
"Off" appears on the display.
to switch the ap-
.
.
.
Advertisement
Table of Contents
