RECOMMENDATIONS AND SUGGESTIONS The instructions for use apply to several versions of this appliance. You may therefore find descriptions of individual features that do not apply to your specific appliance. INSTALLATION • The manufacturer accepts no liability for damage or injury as a result of incorrect installation or improper use.
Page 4
• If the installation instructions for the gas hob specify a greater distance compared to the one indicated, this has to be taken into account. Comply with the current regulations on air discharge into the atmosphere. • Only use screws and fittings that are suitable for the hood. Warning: failure to install the screws or fixing devices according to these instructions may result in electrical shock hazards.
Page 5
MAINTENANCE • Switch off or unplug the appliance from the mains supply before carrying out any cleaning or maintenance. • Clean and / or replace the filters after the length of time specified (fire hazard). • The grease filters must be cleaned every 2 months of operation, or more frequently in the case of particularly heavy use.
INSTALLATION Installing the extractor hood • If the ceiling is not strong enough at the suspension point, the installer must strengthen it by fixing suitable plates and backplates to parts that are structurally sound. ELECTRICAL CONNECTION • Connect the hood to the mains power supply via a two-pole switch that has a contact gap of at least 3 mm.
Control panel FUNCTION BUTTON Switches the lights On / Off at maximum intensity. Switches the motor On / Off at the lowest speed.
Page 9
REMOTE CONTROL This appliance can be controlled using a remote control powered by standard 12 V 23 A carbon- zinc alkaline batteries (not included). • Do not place the remote control close to heat sources. • Dispose of used batteries properly. Control panel FUNCTION BUTTON...
MAINTENANCE Opening the panel • Open the panel by pulling it. • Clean the outside using a damp cloth and a neutral detergent. • Clean the inside using a damp cloth and a neutral detergent. Do not use wet cloths or sponges, or jets of water. Do not use abrasive substances. Grease filters CLEANING THE SELF-SUPPORTING METAL GREASE FILTERS •...
Page 11
Activated Carbon Filter (Recirculation version) The activated carbon filter is not washable and cannot be regenerated. It must be replaced approximately every 4 months of operation, or more frequently in the case of particularly heavy use. REPLACING THE FILTER • Open the panel by pulling it. •...