Table of Contents
Advertisement
11. Tilt the appliance backwards and remove the adjustable foot (11).
12.
12
11
11
13.
2
1
14.
15.
2
A
16.
1
17. Open the top door and replace the door rack; then, close the door.
1 2
3
13
12
14
2
1
11
14
3
A
Replace the upper hinge cap (1).
2
1
3
Undo the three screws on the bottom hinge
(14) and remove it. Remove the extra foot
(12) from the bottom hinge pin (13).
Unscrew the pin (13) from the bottom hinge
and screw it onto the opposite side of the
hinge, complete with the extra foot (12).
Attach the hinge (14) onto the opposite side
using the screws. The screws should be
attached in the order shown in the figure
below. First, tighten the screw 1, followed
by screws 2. Then, screw on the adjustable
feet (11).
Place the bottom door onto the bottom
hinge and hold them in place. Rotate the
middle hinge by 180°. Place the washer in
the correct position and adjust the position
of the middle hinge so that you can install
and fix the bottom door.
Correctly position the top door, run the
connector (A) through the hole in the top
hinge (3) and use the screws (2) to attach
it. Hold the top door in place while
positioning them. Reconnect the connector
(A).
Note: If your model has a handle, then move it
to the opposite side by following the
instructions below.
Remove the caps (1) and undo the two screws
(2) as shown in the figure. Rotate the handle (3)
by 180° and replace it on the opposite side.
Then, fasten the screws (2) and replace the
caps (1).
17
Advertisement
Table of Contents
