Initial Setup; Camera Activation - Provision ISR DB-320WIPN Quick Manual

2) Initial Setup

The initial connection should be done using Ethernet Cable. Make sure the camera got an IP
address from the router, and that it is connected to the internet

3) Camera Activation

The camera's default state is "Inactive". This means that the camera must be activated
before it can be used. The camera can be activated by 3 methods:
❖ IP Manager Tool: Select the camera(s) you wish to activate, set the new admin
password and click activate (Note: the activation password must contain at least 8
characters and include 1 letter, 1 number, and 1 special character).
After setting the password, you will have to set the answer to 3 recovery questions of
your choice. These recovery questions can be used in case you have lost the admin
password you have set.
❖ Logging into the camera web page: When browsing to the camera for the first time,
you will be prompted to activate it. Use credentials admin/123456 for the first login,
then you will be prompted to set the new admin password and click activate (Note:
the activation password must contain at least 8 characters and include 1 letter, 1
number,
After setting the password, you will have to set the answer to 3 recovery questions of
and 1
5
Video Doorbell Quick Guide
special character).