Safety Precautions - Panasonic DVD-RV41 Operating Instructions Manual

CAUTION!
THIS PRODUCT UTILIZES A LASER.
USE OF CONTROLS OR ADJUSTMENTS OR PERFORM¬
ANCE OF PROCEDURES OTHER THAN THOSE SPECI¬
FIED HEREIN MAY RESULT IN HAZARDOUS RADIATION
EXPOSURE.
DO NOT OPEN COVERS AND DO NOT REPAIR
YOURSELF. REFER SERVICING TO QUALIFIED
PERSONNEL.
WARNING:
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR
PRODUCT DAMAGE, DO NOT EXPOSE THIS APPLIANCE
TO RAIN, SPLASHING, DRIPPING OR MOISTURE.
SUOMI
VAROITUS!
LAITTEEN KAYTTAMINEN MUULLA KUIN TASSA KAYT-
TOOHJEESSA MAINITULLA TA VALLA S A ATT A A ALTIS-
TAA KAYTTAJAN TURVALLISUUSLUOKAN 1 YLITTA-
VALLE NAKYMATTOMALLE LASERSATEILYLLE.
VAROITUS:
TULIPALO-, SAHKOISKUVAARAN TAI MUUN VA-
HINGON VAHENTAMISEKSI El LAITETTA SAA AL-
TISTAA SATEELLE, ROISKEELLE, VESIPISAROILLE TAI
KOSTEUDELLE.
NORSK
ADVARSEL!
DETTE PRODUKTET ANVENDER EN LASER.
BETJENING AV KONTROLLER, JUSTERINGER ELLER
ANDRE INNGREP ENN DE SOM ER BESKREVENT I
DENNE BRUKSANVISNING, KAN FORE TIL FARLIG BE-
STRALING.
DEKSLER MA IKKE APNES, OG FORS0K ALDRI A RE-
PARERE APPARATET PA EGENHAND. ALT SERVICE
OG REPARASJONSARBEID MA UTFORES AV KVALIFI-
SERT PERSONELL.
ADVARSEL:
FOR A REDUSERE FAREN FOR BRANN, STROMSJOKK
ELLER SKADER PA PRODUKTET, MA DETTE APPARA¬
TET IKKE UTSETTES FOR REGN, VANNSPRUT, VANN-
DRAPER ELLER FUKTIGHET.
- VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN.
AVOID DIRECT EXPOSURE TO BEAM. _(FDA 21 CFRJ
" VIStBLE ANQ INVISIBLE LASER RADIATION WHEN OPEN.
AVOID EXPOSURE TO BEAM QECSOagS 1
- flAYOWEUEOT LASER VlSBLE ET INVISIBLE EN CAS D OUVERTURE.
-
UBSSBM
UANGEPEUSE AJJ FAJSCEW.
ADVARSEL- -
as
(Inside of unit)
SAFETY PRECAUTIONS
Set the unit up on an even surface away from direct sunlight, high
temperatures, high humidity, and excessive vibration. These condi¬
tions can damage the cabinet and other components, thereby short¬
ening the unit's service life.
Place it at least 15 cm away from wall surfaces to avoid distortion
and unwanted acoustical effects.
Do not place heavy items on the unit.
Do not use high voltage power sources. This can overload the unit
and cause a tire.
Do not use a DC power source. Check the source carefully when
setting the unit up on a ship or other place where DC is used.
Ensure the AC mains lead is connected correctly and not dam¬
aged. Poor connection and lead damage can cause fire or electric
shock. Do not pull, bend, or place heavy items on the lead.
Grasp the plug firmly when unplugging the lead. Pulling the AC
mains lead can cause electric shock.
Do not handle the plug with wet hands. This can cause electric
shock.
Do not let metal objects fall inside the unit. This can cause electric
shock or malfunction.
Do not let liquids get into the unit. This can cause electric shock or
malfunction. If this occurs, immediately disconnect the unit from ihe
power supply and contact your dealer.
Do not spray insecticides onto or into the unit. They contain flam¬
mable gases which can ignite if sprayed into the unit.
Do not attempt to repair this unit by yourself. If sound is interrupted,
indicators fail to light, smoke appears, or any other problem that is not
covered in these instructions occurs, disconnect the AC mains lead
and contacl your dealer or an authorized service center. Electric
shock or damage to the unit can occur if the unit is repaired, disas¬
sembled or reconstructed by unqualified persons.
Extend operating life by disconnecting the unit from the power
source if it is not to be used for a long time.
LUOKAN 1 LASERLAITE
KLASS 1 LASER APPARAT
Do not place the unit
on amplifiers or equip¬
ment that may become
hot.
The heat can damage the unit.
$ * <>