Channel Seeking Operation.17 - Uniden SUNDOWNER UH-088 Owner's Manual

Channel Seeking Operation
Unlike normal scanning, CHANNEL SEEK is used more often when checking for
active channels.
If a signal is detected, while seeking, the UH-088 will tune to that signal for 4 seconds
only and then resumes Seeking Operation.
Changing from SCAN to SEEK Mode operation.
1. Firstly, activate SCAN mode.
2. Press and hold SCAN until a "beep" is heard. The
SCN icon starts to flash.
3. If an active channel is detected the UH-088 will stop
on that channel for 4 seconds, (eg. CHI7)
4. After 4 seconds, the UH-088 will start seeking again
for active channels.
5. If you find the channel interesting, simply press either
the PTT switch or the SCAN key to stop the operation
before the 4 second timer elapses.
When SCAN is pressed again SEEK is still the mode of operation.
To change back to SCAN, while SEEKING, press and hold
SCAN until a beep is heard. The SCN icon stops flashing.
Note: SEEK checks the same channel stored in SCAN memory. Thus, you can Seek
either in OS or GS Mode.
17