Listening To The Sound - Technics SU-V570 Operating Instructions Manual

Listening to the Sound
2 3
Listening to the phono disc or tapes,
(=) fom
Set the volume control to the "co" position.
Switch ON the power switch.
3 sees
Select the speaker system [main (A) and/or
second (B)} to be used.
4 power amp direct
Set the power amplifier direct switch to the
"off" position.
5 [input selector]
Select the sound source.
tape 2/DAT: Set to this position to listen to equipment con-
nected to the "TAPE 2/DAT" terminals.
tape 1: Set to this position to listen to the tapes.
CD: Set to this position to listen to compact discs.
tuner: Set to this position to listen to radio broadcasts.
phono: Set to this position to listen to phono discs.
Then, set the phono cartridge selector to the posi-
tion which corresponds to the type of cartridge
used on the turntable. (Refer to "phono selector"
on page 8.)
aux: Set to this position to listen to equipment connected
to the "AUX" terminals.
Begin operation of the components to be
used. |
Refer to the operating instructions of each component.
volume
Adjust the volume level.
Adjust the tone quality, etc. (Refer to page 8.)
f
A
Volume
indicator
Listening to a component connected
to the "POWER AMP DIRECT"
terminals
fl Follow steps 1 — 3 described at the left.
Set the power amplifier direct switch to the
"on" position.
(The volume indicator will illuminate.)
2
B iinet
Adjust the volume level using this scale.
Note:
The tone quality, the mode,
the loudness, and the
balance cannot be ad-
justed.
After listening is finished
Use the volume control to reduce the volume level and switch
OFF the power of each unit.