Table of Contents
Advertisement
Windscreen
Use the standard windscreen for general voice and instrumental applications.
When you speak, you may hear vocal pops from some consonant sounds (known as plosives). To prevent more plosive
sounds and wind noise, you can use the larger A7WS windscreen.
Mounting Instructions
The default setup for the SM7B is for a boom mount. To set up the SM7B for a microphone stand:
1.
Remove tightening nuts on the sides.
2.
Remove the fitted washers, the lock washers, the outer brass washers, and the brass sleeves.
3.
Slide the bracket off the microphone. Be careful not to lose the washers still on the microphone.
4.
Invert and rotate the bracket. Slide it back onto the bolts over the brass and plastic washers still on the microphone.
The bracket should fit so the XLR connector faces the rear of the microphone and the Shure logo on the back of the mi
crophone is right-side up.
5.
Replace the brass sleeves. Be sure they are seated properly within the inner washers.
6.
Replace the outer brass washers, the lock washers, and the fitted washers.
7.
Replace the tightening nuts and tighten the microphone at the desired angle.
Note: If the tightening nuts do not hold the microphone in place, you may need to re-position the brass sleeves and the washers.
Velcro Cable Tie
Use the enclosed velcro tie to secure the cable.
Shure Incorporated
4/13
Advertisement
Table of Contents
