D+H BRM-24-3 Original Instructions

D+H Downloads
Intended use
The signalling module is used to transmit the status of the CPS-B using
isolated bistable relays.
Technical data
General
Typ:
Rel. air humidity (operation):
Temperature range:
FFC terminal
Supply voltage:
Max. current consumption:
Relay terminals
Switching voltage:
Max. current consumption:
Features
Output of the signals via the relays:
Relay X1: Group fault
Relay X2: Battery failure
Relay X3: General malfunction
- Temperature sensor error
- Temperature alarm
- Group software fuse triggered
- Group hardware fuse triggered
- Group ED fuse triggered
- Service timer expired
- Mains outage
Installation and connection
The module is attached to the housing of the CPS-B using spacers. The
CPS-B and BRM-24-3 are connected with a FFC cable (blue side facing
upwards). The spacer and FFC cable are included in the scope of supply.
The voltage for the relay outputs (NO, NC) is applied to the relays at
COM.
Notice/information:
The CPS-B requires at least version SW 90001B4 or newer and the
equipped terminal J5 (not installed in some 2.5A control panels).
99.828.61 1.0/02/24
Original instructions
Connection
X1
FFC cable
BRM-24-3
20% RH ... 90%RH
0°C ... +40°C
5V DC (± 10%)
1A
110V DC / 125V AC
1A
X2 X3
WARNING
Read all safety warnings, instructions, illustrations and specifications
provided with this product.
Failure to follow all instructions listed below may result in electric shock,
fire and/or serious injury.
Save all warnings and instructions for future reference.
Safety notes
- Connection must be carried out by a certified electrical technician!
- Operating voltage 24 V DC!
- Do not lay 24 V DC and 230 V AC cables in the same cable duct!
- Use only in dry rooms
- Only use unmodified original D+H parts.
Disposal
Electrical devices, accessories, batteries and packaging should be sorted for
environmental-friendly recycling. Do not dispose electrical devices and
batteries into household waste!
Only for EC countries:
According the European Guideline 2012/19/EU for waste electrical and
electronic equipment and its implementation into national right, electrcal
devices that are no longer usable must be collected separately and dispo-
sed of in an environmentally correct manner.
Declaration of Conformity
We declare under our sole responsibility that the product described under
"Technical Data" is in conformity with the following regulations:
2011/65/EU, 2014/53/EU
S.I. 2012/3032, S.I. 2017/1206
Technical file at:
D+H Mechatronic AG, D-22949 Ammersbek
Dirk Dingfelder Maik Schmees
CEO CTO
17.01.2024
English
BRM-24-3
1/2