TP-Link Festa FS308GP Installation Manual

Festa Smart Switch
©2024 TP-Link
Connection for PoE Switch
For simplicity, we will take Festa FS310GP for example throughout the Guide.
DC Power Adapter
AC Power Cord
PoE+ Ports (1-8)
Powered Device (PD)
IP Camera AP IP Phone
Note:
1. The PoE ports can also connect to non-PoE devices, but only transmit data.
2. The PoE ports shall not be used to charge lithium batteries or devices supplied
by lithium batteries.
3. Maximum PoE power is 30 W for each PoE port, and total PoE budget is 62 W
(for Festa FS308GP) / 61 W (for Festa FS310GP) respectively.
4. PoE budget calculations are based on laboratory testing. Actual PoE power
budget is not guaranteed and will vary as a result of client limitations and
environmental factors.
Installation
Note: For simplicity, we will take Festa FS310GP for example.
Desktop:
Attach the supplied feet to the bottom of the switch to prevent it from
slipping when placed on a desktop.
7106511327 REV1.1.0
SFP Slots
Router/Gateway
LAN Port WAN Port
Internet
PC
LED Explanation
LED
Explanation
PWR On/Off: Power on/off
Blinking: System running normally
SYS
On/Off: System running abnormally
On (Green): Running at 1000 Mbps
On (Yellow): Running at 10/100 Mbps
Speed
Blinking: Transmitting/receiving data
Off: No connected device
Green/Yellow On: Running at 1000/100 Mbps
SFP1/SFP2
Blinking: Transmitting/receiving data
(For Festa FS310GP only)
Off: No connected device
On: Providing PoE power
PoE Status
Blinking: Current-overload/Short-circuit/Connected to a
(For Port 1-4 of Festa FS308GP
non-standard PD/Power exceeded the user-defined value
/Port 1-8 of Festa FS310GP)
Off: Not providing PoE Power
On: Remaining power supply ≤ 7 W
PoE Max
Blinking: Remaining power supply keeps ≤ 7 W for more than
(For Festa FS308GP/
2 minuites
Festa FS310GP)
Off: Remaining power supply keeps ＞ 7 W
Connection for Non-PoE Switch
For simplicity, we will take Festa FS308G for example throughout the Guide.
Note:
1. Port 8 is a PD (Powered Device) port. When powered through port 8, the
switch can only be powered by power supplies that comply with the 802.3af/at
standard and Power Source Class 2 (PS2) or Limited Power Source (LPS)
defined in the standard of IEC 62368-1.
2. The DC power input takes precedence over the PD port. If the DC input fails,
the PoE input on the PD port willl supply power instead.
Wall-mounting:
Drill two holes on the wall according to the mounting holes on the
bottom of the switch, then secure the switch to the wall with two
suitable screws (not provided).
Note:
For detailed information, please refer to
the Wall Mounting Guide on the device's
support page.
Router/Gateway
LAN Port WAN Port
Internet
PC