Yamaha YZF690 Owner's Manual page 30

Instrument and control functions
Right
4
1. Engine stop switch "
2. Hazard switch "OFF/
3. Start switch " "
Pass switch " "
Press this switch to flash the headlight.
TIP
When the dimmer switch is set
to " ", the passing switch has no ef-
fect.
Dimmer switch " /
Set this switch to "
beam and to " " for the low beam.
Turn signal switch "
To signal a right-hand turn, push this
switch to "
1 1 1
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
2 2
lights, push the switch in after it has re-
turned to the center position.
3 3
Horn switch "
/ "
" Press this switch to sound the horn.
Engine stop switch "
EAU12352
Set this switch to "
starting the engine. Set this switch
to "
of an emergency, such as in the event
of an overturn or if the throttle is stuck.
Start switch " "
EAU12402 Push this switch to crank the engine
"
with the starter. See page 6-2 for start-
" for the high
ing instructions prior to starting the en-
gine.
/ "
". To signal a left-hand
". When
"
/ "
" (run) before
" (stop) to stop the engine in case
4-12
EAU12461
Hazard switch "OFF/ "
Use this switch to turn on the hazard
lights (simultaneous flashing of all turn
signal lights). The hazard lights are
used in case of an emergency or to
warn other drivers when your vehicle is
stopped where it might be a traffic haz-
ard.
The hazard lights can be turned on or
EAU12501 off only when the main switch is in the
"ON" position. You can turn the main
switch to the "OFF" or "LOCK" posi-
tion, and the hazard lights will continue
EAU12664
to flash. To turn off the hazard lights,
turn the main switch to the "ON" posi-
tion and operate the hazard switch
again.
NOTICE
Do not use the hazard lights for an
EAU12713 extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
EAU88273
ECA10062