Advertisement
Configuring the Terminal from the Web UI
Settings>IP Address /DHCP:
•
The terminal defaults to NAT mode. See the User Manual
for instructions on Relay, NAPT or PPPoE modes.
Connections>Manage APN:
•
Check the APN that you want to use is listed at the top under
Defined APNs. If not, add it and any user credentials (if
required), click Save and then highlight it on the left hand
side and click Make Default.
M2M Settings
Context Watchdog
•
Set to ON
•
Primary Ping Address - this needs to be a server address that
is within your VPN or if you are routed to the Public Internet,
you can use a DNS Server (e.g. 4.2.2.1)
•
Secondary Ping Address - this needs to be a server address
that is within your VPN or if you are routed to the Public
Internet, you can use a DNS Server (e.g. 8.8.8.8)
•
Time between pings – can be set to a little longer than the
typical frequency with which data is sent by the terminal.
This avoids unnecessary pings adding to your data usage.
•
Ping required: Recommended setting is No.
Always On Context
•
Always On context needs to be set to ON.
•
Static ACA IP Address – If your device uses DHCP, leave this
field blank or 0.0.0.0. If the device uses a static IP address,
enter the static address here. Configure the device with
subnet mask 255.255.255.0 and a default gateway of
192.168.128.100.
•
APN Configuration – defaults to the default APN but you can
also select the appropriate APN from the drop down list
•
Click on Apply
•
Click Reboot and wait for the terminal to reboot.
Test Your Configuration
•
Connect your device to the 9502 via Ethernet. If you want to
monitor the unit via the Web UI, connect your computer via
the USB port. Ensure that you have the Hughes USB driver
installed, unless using a Gen2 9502.
•
Open the Web UI and go to the Connections>Manage
Context Page. Once a PDP context has been automatically
setup you should see something similar to the example
below. The global IP address will be listed if you have a data
session active.
In this example, the connected device is accessible via the
Inmarsat network at the private IP address 10.186.133.28.
Switching between M2M and BGAN service
•
The 9502 automatically switches between M2M and BGAN
service based on the type of SIM inserted. Power off the
9502 before changing the SIM.
•
The Web UI indicates that the terminal is enabled for BGAN
Services by the 9502B in the upper left-hand corner of the
web pages.
H71324 Rev B
Advertisement
