Wet Vacuuming - Ryobi RACWDV30MC Owner's Operating Manual

9

WET VACUUMING

BEFORE INSTALLING, REMOVING OR CLEANING
THE VACUUM CLEANER FILTER, ENSURE THAT
THE POWER CORD IS SWITCHED OFF AND
UNPLUGGED.
1. For wet vacuuming, release the locking latch and remove
the cartridge filter and paper dust bag/plastic disposal bag
used for dry vacuuming. Carefully install the foam filter
over the internal filter cage to make sure the whole cage
is covered.
2. Turn the vacuum on by pressing the switch to the "I" ON
mode.
3. Remember to press the switch to the "O" OFF mode after
wet vacuuming.
4. After wet application, to empty the tank, unscrew the cap
on the drain plug and let the dirty water out.
5. Remember to empty the tank and put the cap back on
the drain plug after emptying.
2
1
3
WARNING
4
The foam filter must be removed after wet vacuuming,
and a cartridge filter must be installed before dry
vacuuming again.
IMPORTANT!
When vacuuming large quantities of liquids, do not
immerse the nozzle completely in the liquid; leave a gap at
the tip of the nozzle opening to allow air inflow. The
machine is fitted with a float valve that stops the suction
action when the container reaches its maximum
capacity. You will notice an increase in the pitch of motor
sound. When this happens, turn of the machine,
disconnect from power supply, and drain the liquid into a
suitable receptacle or drain.To continue vacuuming, refit
the container with the drain cap. After wet vacuuming, turn
the machine off and remove plug from power supply.
Empty the container, clean and dry the inside and outside
before storage.
5
WARNING