Table of Contents
Advertisement
Emptying the dust case and cleaning the filters
Cleaning the filters
Clean filter
1
Open the clean filter.
Set the dust case on the floor.
Dust case
2
Remove dust and debris from the clean filter
Detach the clean filter.
Clean filter
Sponge
filter
Wash the sponge filter
with water if there is dirt
on the filter.
(P.E-21)
Note
Be sure to attach the
sponge filter after
emptying the dust case
Perform maintenance (wash with water) when you are concerned about dirt or the
or cleaning the filters.
suction power is weak. (P.E-21)
3
Attach the clean filter.
Attach the clean filter in the reverse order
of removal.
4
Close the clean filter.
Press firmly until you hear a "click" sound.
Note
Make sure the sponge filter
is attached.
Sponge
filter
E-18
(continued)
Grab and hold the lower part of the dust case, lift up the knobs of the
clean filter, and open the cover in the direction indicated by the arrow.
Knobs
Clean filter
Remove attached dust along
the folds of the clean filter with
the maintenance brush.
Maintenance
Detach
brush
Note
When removing dust and debris, do not slap the clean filter
onto the floor, etc. Failure to do so might cause damage.
To clean the clean filter, use the maintenance brush that
was provided with the vacuum cleaner.
Do not scrub the filter excessively hard using the maintenance brush.
Otherwise, the clean filter may tear.
Clean filter
Click
Clean filter
Inner cylinder filter
1
Open the dust case lid (P.E-17) and remove the inner cylinder filter.
Turn the inner cylinder filter in the Unlock
direction as far as it will go.
2
Remove dust and debris from the inner cylinder filter.
You can easily remove dust and debris caught in the inner cylinder
filter by sliding the maintenance brush in the direction indicated by
the arrow.
3
Attach the inner cylinder filter and close the dust case lid. (P.E-17)
Match the inner cylinder filter with the center
of the dust case.
Midsection
Inner cylinder filter
Note
4
Attach the maintenance brush to the back side of the dust case.
Attach
Attach the maintenance brush to the hook of
the dust case.
Note
Lift the inner cylinder filter straight up.
Inner cylinder filter
Push the inner cylinder filter down and turn the inner
cylinder filter in the Lock direction until you hear a click.
Dust case
Inner cylinder filter
If the filter is not securely attached, it might fall when you empty the dust case. Similarly, if you use the
vacuum cleaner without securely attaching the filter, strange sounds might come from around the filter.
Firmly attach the knob of the maintenance
brush until you hear a "click" sound.
Dust case
Hook
Attach
Maintenance
brush
If the vacuum cleaner is started without the maintenance brush attached to the back side of the
dust case equipped on the vacuum cleaner, the brush might become detached. Securely attach
the maintenance brush to the back side of the dust case.
Note
Dust and debris might spill
when you remove the inner
cylinder filter. To catch the
dust and debris, spread
newspaper on the ground
before you remove the in-
ner cylinder filter.
Inner cylinder filter
Maintenance brush
Click
Inner cylinder filter
Dust case lid
Knob
Click
Push
E-19
Advertisement
Table of Contents
