Advertisement
STEP 5
1
(Figure 4)
c. Attach Bottom Mount Cap 7a to Base 7b over the pole.
Insert M6 x 60mm Bolts 8 (x4) and tighten to M6 Washers 14 (x4)
and M6 Nuts 13 (x4) on the inside of the console.
(as shown in Figure 5)
STEP 6
The assembly
should now look like this
STEP 7
c. Fasten Screws
a. Hold the Bottom Mount Base 7b (x2) up in place,
b. Drill 4 holes using 6.5mm Drill Bit 12 (as shown in Figure 4)
1
11 (x4) to 3a and 3b
(as shown in Figure 7 & 8)
marking the position of the 4 holes on the console. (as shown in Figure 4)
Ensure no wiring in the console will be damaged.
Ensure no wiring in the console will be damaged.
2
a. Repeat Step Four for the Top Mounts 6 (x2) attaching to
the Upright Rear poles 2 (x2).
Ensure the T-Top maintains a slight angle when mounted
(as shown in Figure 6).
b. Repeat Step Five for the Bottom Mounts 7 (x2)
attaching to the Upright Rear poles 2 (x2).
(Figure 7)
(Figure 8)
1
(Figure 5)
2
(Figure 6)
Advertisement
