Advertisement
STEP 3
2
STEP 4
1
1
1
1
2
3a
3b
2
a. Hold the frame and Top Mount Base 6b (x2) up in place,
marking the position of the 4 holes on the console.
Ensure no wiring in the console will be damaged.
b. Drill these 4 holes using 6.5mm Drill Bit 12 (as shown in Figure 2)
Ensure no wiring in the console will be damaged.
c. Attach Top Mount Cap 6a to Base 6b over the pole.
Insert M6 x100mm Bolts 9 (x4) and tighten to M6 Washers 14 (x4)
and M6 Nuts 13 (x4) on the insideof the console.
(as shown in Figure 3)
(Figure 2)
a. Flip the frame upside-down (as shown in the diagram)
b. Connect Upright Front 1 (x2) into the inserts on Front Crossbar 3a
c. Connect Upright Rear 2 (x2) into the inserts on Rear Crossbar 3b
d. Screw 10 (x4) through the pre-drilled hole in each Upright
(as shown in Figure 1)
(Figure 1)
(Figure 3)
1
Advertisement
