Page 1
HEAVY DUTY T-TOP (MA 185) INSTRUCTIONS TOOLS REQUIRED (Not Supplied) Phillips screw driver Cordless Drill Masking tape Tape measure Pencil Front Crossbar Top Mount Bottom Mount Rear Crossbar Top Side Frame M6 x 60mm M6 x 100mm Screw Screw Bolt...
Page 2
STEP 3 a. Flip the frame upside-down (as shown in the diagram) b. Connect Upright Front 1 (x2) into the inserts on Front Crossbar 3a c. Connect Upright Rear 2 (x2) into the inserts on Rear Crossbar 3b d. Screw 10 (x4) through the pre-drilled hole in each Upright (as shown in Figure 1) (Figure 1) STEP 4...
Page 3
STEP 5 a. Hold the Bottom Mount Base 7b (x2) up in place, marking the position of the 4 holes on the console. (as shown in Figure 4) Ensure no wiring in the console will be damaged. b. Drill 4 holes using 6.5mm Drill Bit 12 (as shown in Figure 4) Ensure no wiring in the console will be damaged.
Page 4
STEP 8 STEP 9 Fasten Screws 11 (x4) to the Tighten Screws 10 (x4) through the Frame Sides 4 (x2) central hole of the (as shown in the diagram) bottom mount 7a STEP 10 Feed rope through loops of the front corners Outside *Dotted line represents the rope Tighten...