Connecting Ethernet Cable - HPE Aruba Networking 670 Series Installation Manual

Connecting Ethernet Cable

To connect an Ethernet cable to the access point, perform the following steps using the M20 cable
gland.
Failure to use the included Ethernet cable gland can lead to connectivity and PoE issues.
The Ethernet cable is not included and must be purchased separately. Purchase a suitable UV-resistant,
outdoor rated, CAT 5E or better shielded cable for use with the access point.
1. Remove the dust cap from the Ethernet port.
2. Slide the sealing nut, clip, seals, gland body, and O-ring over the cable.
3. Insert the RJ45 connector to the Ethernet port on the AP.
4. Place the O-ring on the gland body, and ensure it is in place.
5. Thread the gland body into the Ethernet port, and tighten to a torque of 8.9 in/lbs (1.0 Nm).
6. Combine the two split seals over the cable, and place them on the gland body.
7. Move the clip towards the gland body, passing over the seals, until the clip properly fits into the
gland body.
8. Tighten the sealing nut onto the gland body to a torque of 8.9 in/lbs (1.0 Nm).
9. Connect the other end of the Ethernet cable to a PoE port of a compliant PoE Injector or PoE
switch.
HPE Aruba Networking 670 Series Outdoor Access Points | 14