Table of Contents
Advertisement
Console Port Default State
When the access point is in factory default state the console interface (both physical port and BLE) is
enabled with default credentials (username is "admin" and password is the serial number of the unit).
Once the AP has established a connection with its management platform, the console port state
(enabled/disabled) and access credentials are updated to match what's configured there. State and
credentials are maintained if the AP is power-cycled or rebooted.
USB Host Interface Default State
When the access point is in factory default state the USB host interface is powered and enabled,
assuming the AP is not in a restricted power mode. On some AP models the USB port may be disabled
when a POE source with insufficient power budget is used. Once the AP has established a connection
with its management platform, the USB host interface state is updated to match what's configured
there. This state is maintained if the AP is power-cycled or rebooted.
HPE Aruba Networking 670 Series Outdoor Access Points | Installation Guide
10
Advertisement
Table of Contents
