Grounding Access Point - HPE Aruba Networking 670 Series Installation Manual

Outdoor access points

Hide thumbs

Table Of Contents

Table of Contents

Table 5: Mount Kits for 670 Series Access Point

Part

Description

Number

R9H97A

AP-OUT-MNT-V1A long-arm wall or pole mount kit. it's

usually for omni antenna and connectorized APs.

JW053A

AP-270-MNT-V2 short-arm wall or pole mount kit. it's

usually for omni antenna and connectorized APs.

JW054A

AP-270-MNT-H1 articulating up-down wall or pole

mount kit. It's usually for directional antenna APs

JW055A

AP-270-MNT-H2 non-articulating wall mount for

directional APs, or ceiling mount for omni antenna APs

R6W11A

AP-270-MNT-H3 dual-articulating (up-down, left-right)

for wall or pole mounting of directional APs, or ceiling

mounting APs on uneven ceilings

All HPE Aruba Networking access points should be professionally installed by a professional installer. The installer

is responsible for ensuring that grounding is available and meets applicable national and electrical codes. Failure

to properly install this product may result in physical injury and/or damage to property.

Tous les points d'accès HPE Aruba Networking doivent impérativement être installés par un professionnel agréé.

Ce dernier doit s'assurer que l'appareil est mis à la terre et que le circuit de mise à la terre est conforme aux codes

électriques nationaux en vigueur. Le fait de ne pas installer correctement ce produit peut entraîner des blessures

corporelles et / ou des dommages matériels.

This 670 Series access point is intended for installation in a RESTRICTED ACCESS LOCATION attached to a pole or

installed on a wall. Installers should disconnect power before working with or near the access point.