OVER TEMPERATURE PROTECTION
If the battery or power inverter temperature exceeds 70°C
during operation, the power button LED indicator will glow
solid red for 1 minute, and then the temperature-protection
circuit will shut off the power inverter to protect from
overheating damage. Allow the battery and the power
inverter to cool until the temperature drop below 67°C
before restarting.
LOW BATTERY PACK CHARGE PROTECTION
When the batter pack charge reaches a low level, the
power button LED indicator will flash for 1 minute and
then the power inverter will automatically shut down.
Charge the battery pack.
OVERLOAD OR SHORT CIRCUIT PROTECTION
When the connected AC device draws more than the
rated power of the port, the power button LED indicator
will flash red quickly for 1 minute, and then the power
inverter will automatically shut down.
Disconnect the AC device.
To connect external devices:
1. Install a battery pack onto the power inverter.
2. Press the power button to turn on the power
inverter. The LED in the power button will glow solid
green, which means the power inverter is ready for
supplying power.
3. Connect devices into the power inverter's USB ports
and/or 220-240V AC output port. The inverter will
begin powering the devices automatically.
4. When the power inverter is not in use, disconnect
devices from the power inverter, then press the
power button to turn off the power inverter.
5. Remove the battery pack from the power inverter.
TROUBLESHOOTING
PROBLEM
The power inverter cannot be turned
on.
6
56 VOLT POWER INVERTER — PAD1800E
MAINTENANCE
disconnect all devices and remove the battery pack from
the power inverter when cleaning or performing any
maintenance.
replacement parts. Use of any other parts may create a
hazard or cause product damage. To ensure safety and
reliability, all repairs should be performed by a qualified
service technician.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use a clean cloth to remove dirt, dust, oil, grease, etc.
gasoline, petroleum-based products, penetrating oils,
etc. to come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may result in
serious personal injury.
STORING THE UNIT
◾
Remove the battery pack from the power inverter.
◾
Clean the power inverter thoroughly before storing.
◾
Store the unit in a dry, well-ventilated area, locked-up
or up high, out of the reach of the children. Do not
store the unit on or adjacent to fertilizers, gasoline, or
other chemicals.
Protecting the environment
CAUSE
◾
The battery pack capacity is
depleted.
◾
The battery pack is too hot.
◾
Other electronics error.
WARNING:
To avoid serious personal injury, always
WARNING:
When servicing, use only identical EGO
WARNING:
Do not at any time allow brake fluids,
Do not dispose of electrical equipment,
used battery and charger into household
waste! Take this product to an authorized
recycler and make it available for
separate collection. Electric tools must be
returned to an environmentally compatible
recycling facility.
SOLUTION
◾
Charge the battery pack.
◾
Cool the battery pack until its
temperature drops below 67°C.
◾
Contact EGO customer service
center for repair.
Need help?
Do you have a question about the NEXUS ESCAPE PAD1800E and is the answer not in the manual?