Audio Setup - Philips CTS4000 Manual

Audio setup

1
Press OPTIONS.
[ General Setup ] menu is displayed.
2
Press V to select
press B.
3
Select an option, then press OK.
Audio Setup
HDMI Audio
Audio Sync
Night Mode
CD Upsampling
• See the explanations of the above
options in the following pages.
4
Select a setting, then press OK.
• To return to the previous menu, press
BACK.
To exit the menu, press OPTIONS.
•
[ HDMI Audio ]
When you connect this unit and TV with
HDMI cable, select the audio output
setting for this connection.
• [ On ] – the sound is output through
both your TV and this speaker system.
If the audio format on the disc is not
supported, it will be downmixed to
two-channel sound (linear-PCM).
• [ Off ] – disable audio output from
your TV. The sound is only output
through this speaker system.
34 EN
cts4000_12_eng5_final.indd 34 cts4000_12_eng5_final.indd 34
[ Audio Setup ], then
[ Audio Sync ]
Set the default delay time for audio output
when you play a video disc.
1. To start, press OK.
2. Select a speaker delay in the menu,
then press b B to set the delay time.
3. Press OK to confi rm and exit.
[ Night Mode ]
Make loud sound level softer and soft
sound level louder so that you can watch
the DVD movies at a low volume, without
disturbing others.
Note
•
This setting is only applicable to Dolby Digital
encoded DVD.
• [ On ] – for quiet viewing at night
(DVDs only).
• [ Off ] – enjoy surround sound with a
full dynamic range.
[ CD Upsampling ]
Convert the music CD to a higher
sampling rate using sophisticated digital
signal processing for better sound quality.
• [ Off ] – turn off CD-upsampling.
• [ On ] – convert the sampling rate of
the CDs twice as high as the original
rate.
2008-08-13 6:38:25 PM 2008-08-13 6:38:25 PM