Important User Information - Graco MAGNUM TRUEAIRLESS Project Painter Plus Owner's Manual

Important User Information

Before using your sprayer read this Owners Manual for complete instructions on proper use
and safety warnings.
This sprayer is designed to provide superior spray performance with water-based and oil-based
(mineral spirit-type) architectural paints and coatings. This user information is intended to help
you understand the types of materials that can be used with your sprayer.
Please read the information on the material container label to determine if it can be used with
your sprayer. Ask for a Safety Data Sheet (SDS) from your supplier. The container label and
SDS will explain the contents of the material and the specific precautions related to it.
WATER-BASED: The container label should indicate that the material can be
cleaned up with soap and water. Your sprayer is compatible with this type of
material. Your sprayer is NOT compatible with harsh cleaners such as
chlorine bleach.
OIL-BASED: The container label should indicate that the material is
COMBUSTIBILE and can be cleaned up with mineral spirits or paint thinner.
The SDS must indicate that the flash point of the material is above 100° F.
Your sprayer is compatible with this type of material. Use oil-based material
outdoors or in a well-ventilated indoor area with a flow of fresh air. See the
safety warnings in this manual.
FLAMMABLE: This type of material contains flammable solvents such as
xylene, toluene, naphtha, MEK, lacquer thinner, acetone, denatured alcohol,
and turpentine. The container label should indicate that this material is
FLAMMABLE. This type of material is NOT compatible with your sprayer
and CANNOT be used.
FIRE AND EXPLOSION HAZARD
•
Use only non-flammable or water-based
materials, or non-flammable paint thinners.
Do not use materials having flash points
lower than 100° F (38° C). This includes, but
is not limited to, acetone, xylene, toluene, or
naphtha. For more information about your
material, request Safety Data Sheet (SDS)
from the supplier.
•
Spraying flammable or combustible
(oil-based) materials in a factory or fixed
location must comply with NFPA 33 and
OSHA 1910.94(c) requirements in the USA
and with all similar local regulations in other
countries.
3A6430C EN
Thank You for Your Purchase!
Paints, coatings and clean-up materials generally fit
into one of the following 3 basic categories:
Important User Information
3