Table of Contents
Advertisement
F
E
A
B
C
D
A.
UL listed wire nuts
B.
Green (or bare) wire connected to
green/yellow wires
C.
White wires
D.
Black wires
E.
Home power supply cable
F.
UL/CSA approved strain relief
14-3.
Remove the strain relief hole
cover in the terminal box and
install a UL/CSA approved strain
relief.
14-4.
Run home power supply wiring
through strain relief into
terminal box.
Use UL listed wire nuts and
14-5.
connect white wires (C) together.
14-6.
Use UL listed wire nuts and
connect black wires (D) together.
14-7.
Connect green (or bare) ground
wire from home power supply
to the green/yellow ground wire
(B) in terminal box using UL
listed wire nuts.
14-8.
Tighten strain relief screw.
14-9.
Put the wires into the terminal
box and install terminal box
cover.
14-10.
Reconnect power circuit breaker.
15. Attach each magnet to the inner
surface of the upper duct cover
overlapping with the lower duct
cover, and assemble the upper
duct cover in a way that it fits the
mounting bracket.
WARNING
Installation with screws or brackets
other than those specified in the
instruction of this manual may result in
electrical hazards.
NOTE
Magnets are included in the accessory
box.
16. Assemble with 10 mm hood fixing
screws from both sides.
English 15
Advertisement
Table of Contents
