Download Print this page

Whirlpool W7 MD460 Manual page 4

Advertisement

Available languages

Available languages

stated in the user manual. Keep children away from
the installation site. After unpacking the appliance,
make sure that it has not been damaged during
transport. In the event of problems, contact the
dealer or your nearest After-sales Service. Once
installed, packaging waste (plastic, styrofoam
parts etc.) must be stored out of reach of children
- risk of suffocation.
disconnected from the power supply before any
installation operation - risk of electrical shock.
During installation, make sure the appliance does
not damage the power cable - risk of fire or
electrical shock. Only activate the appliance when
the installation has been completed.
Carry out all cabinet cutting works before
fitting the appliance in the furniture and remove
all wood chips and sawdust.
Do not remove the appliance from its
polystyrene foam base until the time of
installation.
After installation, the bottom of the appliance
must no longer be accessible - risk of burn.
Do not install the appliance behind a decorative
door - risk of fire.
If the appliance is installed under the worktop,
do not obstruct the minimum gap between the
worktop and the upper edge of the oven - risk of
burns.
This appliance is intended to be used built-in.
Do not use it freestanding or place into a cabinet.
After unpacking the appliance, make sure that
the appliance door closes properly. In the event
of problems, contact the dealer or your nearest
After-sales Service.
ELECTRICAL WARNINGS
The rating plate is on the front edge of the
oven (visible when the door is open).
It must be possible to disconnect the appliance
from the power supply by unplugging it if
plug is accessible, or by a multi-pole switch
installed upstream of the socket in accordance
with the wiring rules and the appliance must
be earthed in conformity with national electrical
safety standards.
Do not use extension leads, multiple sockets
or adapters. The electrical components must not
be accessible to the user after installation. Do not
use the appliance when you are wet or barefoot.
Do not operate this appliance if it has a damaged
power cable or plug, if it is not working properly,
or if it has been damaged or dropped.
If the supply cord is damaged, it must
be replaced with an identical one by the
manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard -
risk of electrical shock.
If the power cable needs to be replaced,
contact an authorised service center.
The appliance must be
CLEANING AND MAINTENANCE
WARNING: It is hazardous for anyone other
than a competent person to carry out any service
or repair operation that involves the removal of a
cover which give protection against exposure to
microwave energy.
Failure to maintain the oven in a clean
condition could lead to deterioration of the surface
that could adversely affect the life of the appliance
and possibly result in a hazardous situation.
The oven must be cleaned regularly and any
food deposits removed.
WARNING: Ensure that the appliance is
switched off and disconnected from the power
supply before performing any maintenance
operation.
To avoid risk of personal injury
use protective gloves (risk of laceration) and
safety shoes (risk of contusion); be sure to
handle by two persons (reduce load); never use
steam cleaning equipment (risk of electric shock).
Non-professional repairs not authorised by the
manufacturer could result in a risk to health and
safety, for which the manufacturer cannot be
held liable. Any defect or damage caused from
non-professional repairs or maintenance will not
be covered by the guarantee, the terms of which
are outlined in the document delivered with the
unit.
Regularly clean appliance door internal side
and related gasket, without removing it. Use a soft
sponge, mild water and neutral soap; dry using a
neutral soft cloth. Do not use metal scrapers.
Do not use harsh abrasive cleaners or metal
scrapers to clean the door glass since they can
scratch the surface, which may result in shattering
of the glass.
Make sure the appliance has cooled down
before cleaning or performing maintenance. - risk
of burns.
DISPOSAL OF PACKAGING MATERIALS
The packaging material is 100% recyclable and is marked with the
recycle symbol
. The various parts of the packaging must therefore
be disposed of responsibly and in full compliance with local authority
regulations governing waste disposal.
DISPOSAL OF HOUSEHOLD APPLIANCES
This appliance is manufactured with recyclable or reusable materials.
Dispose of it in accordance with local waste disposal regulations.
For further information on the treatment, recovery and recycling
of household electrical appliances, contact your local authority, the
collection service for household waste or the store where you purchased
the appliance. This appliance is marked in compliance with European
Directive 2012/19/EU, Waste Electrical and Electronic Equipment (WEEE)
and with the Waste Electrical and Electronic Equipment regulations
2013 (as amended). By ensuring this product is disposed of correctly,
you will help prevent negative consequences for the environment and
human health. The
symbol on the product or on the accompanying
documentation indicates that it should not be treated as domestic waste
but must be taken to an appropriate collection center for the recycling
of electrical and electronic equipment.
DECLARATIONS OF CONFORMITY
This appliance is in compliance with the European standard EN 60705.
This product contains a light source of energy efficiency class G.

Advertisement

loading