NEC N8190-175 User Manual page 48

4.
Mate the cable connector and the connector of this product firmly in the correct direction.
Push the latch of the Fibre Channel cable to avoid conflict with the computer

flame and then insert the Fibre Channel cable until you hear it click.
Notice
If it is difficult to push the latch of the Fibre Channel cable when connect or remove

the Fibre Channel cable, use a flathead screwdriver to push the latch.
Tips
5.
Mate the other end of the cable connector and the Fibre Channel device firmly in the correct
direction.
 Do not connect this product to a computer or Fibre Channel device that is not
recommended by NEC Corporation. If the product is connected to a computer or
Notice
Fibre Channel device that is not recommended by NEC Corporation, the product
may malfunction or fail.
 Do not use Fibre Channel cable that is not recommended by NEC Corporation. If
the product is connected to Fibre Channel device by Fibre Channel cable that is
not recommended by NEC Corporation, the product may malfunction or fail.
 Use Fibre Channel cables under conditions that conform to the cable
specification (length between device, Fibre Channel data rate and so on).
 Please contact the retailer or service center for the information on recommended
computers, Fibre Channel devices, or Fibre Channel cables.
 Please refer to the user's guide of the product for information on how to setting
Check
Fibre Channel device.
6.
Plug the power cord of the Fibre Channel device into the electrical outlet. For detailed
information, please refer to the user's guide of the Fibre Channel device.
7.
Plug the power cord of the computer into the electrical outlet.
- 46 -