Installing The Handle - EGO PRO X LMX5300SP Manual

ASSEMBLY
WARNING:
If any parts are damaged or missing,
do not operate this product until the parts are replaced.
Use of this product with damaged or missing parts could
result in serious personal injury.
WARNING:
To prevent accidental starting that could
cause serious personal injury, always remove the battery
pack(s) from the machine when assembling parts.
WARNING:
Do not attempt to modify this machine
or create accessories not recommended for use with this
mower. Any such alteration or modification is misuse and
could result in a hazardous condition leading to serious
injury.
UNPACKING
This product requires assembly.
◾
Remove all the accessories from the carton.
CAUTION:
Heavy object. Two persons are required to
lift the mower.
◾
One person should grasp the middle bumper/lift handle
and the other person should grasp two wing bolts to
carefully lift the mower out of the carton.

INSTALLING THE HANDLE

The lawn mower is shipped with the handle partially
assembled.
WARNING:
Do not attempt to start the lawn mower
until the handle is properly and securely installed and
unfolded. Use caution to avoid pinching fingers and cable
between the parts.
1. Unscrew and put aside both wing bolts.
2. Move the handle forward until the locking gear on the
handle assembly is facing the gear on the mower
(Fig. B1).
3. Align the marks on the locking gear and handle
mounting plate as shown in Fig. B2, then insert and
finger-tighten the two wing bolts.
UNFOLDING AND ADJUSTING THE HANDLE (FIG. C)
WARNING:
Be sure not to pinch, kink or stress the
cable when folding or unfolding the handle. Damaging the
cable could impact the activation and operation of the
lawn mower and result in an unsafe operating condition.
WARNING:
self-propel system until the handle has been locked at one
of the three preset operating positions (Upper Operating
Position 3, Middle Operating Position 2, and Lower Operating
Position 1).
1. Loosen the wing bolts on both sides, ensure that the
two gears are fully loose but NOT separated.
2. Turn the handle upward until the arrow mark on the
locking gear aligns with one of the three operating
positions on the handle mounting plate.
3. Tighten the two bolts, make sure the two gears are
fully engaged and the handle is securely fixed.
C-1
C-2
C-3
FOLDING THE HANDLE (FIG. D)
WARNING:
cable when folding or unfolding the handle. Damaging the
cable could impact the activation and operation of the lawn
mower and result in an unsafe operating condition.
1. Loosen the wing bolts on both sides, ensure the two
gears are fully loose but NOT separated.
2. Turn the handle downward until the handle seats in the
storage position.
3. Align the arrow mark on the locking gear with the storage
position mark on handle mounting plate.
4. Tighten the two wing bolts, make sure the two gears are
fully engaged and the handle is securely fixed.
D-1
ASSEMBLING THE GRASS BAG (FIG.E1, E2, E3)
Check the grass bag before assembling, to make sure that
there is no damage.
Assemble the grass bag as illustrated.
ATTACHING/REMOVING THE MULCHING INSERT
(SOLD SEPARATELY)
Install the mulching insert into the mower as shown in
Fig. F.
DANGER:
and other objects through an opening in the machine
housing. Objects thrown with enough force could
cause serious personal injury or death to you or to
bystanders.
56 VOLT LITHIUM-ION CORDLESS MOWER — LMX5300SP
Do not attempt to start the mower and
Lower Operating Position 1
Middle Operating Position 2
Upper Operating Position 3
Be sure not to pinch, kink or stress the
Storage Position
The machine can throw grass clippings
EN
9