Mitsubishi Electric Mr.SLIM SLZ-M FA Series Operation Manual page 9

3. Operation
3.4. Fan speed setting
Fri
28.5
Room
Cool Set temp. Auto
Mode Temp. Fan
F1 F2 F3 F4
Press the [F4] button to go through the fan speeds in the following order.
• The available fan speeds depend on the models of connected indoor
units.
Notes:
The number of available fan speeds depends on the type of unit
●
connected.
In the following cases, the actual fan speed generated by the unit
●
will differ from the speed shown the remote controller display.
1. While the display is in "Standby" or "Defrost" states.
2. When the temperature of the heat exchanger is low in the
heating mode.
(e.g. immediately after heating operation starts)
3. In HEAT mode, when room temperature is higher than the
temperature setting.
4. In COOL mode, when room temperature is lower than the
temperature setting.
5. When the unit is in DRY mode.
3.5. Airflow direction setting
3.5.1 Navigating through the Main menu
<Accessing the Main menu>
Main
F1
Auto
<Item selection>
Main
F1
<Exiting the Main menu screen>
Cool
Mode
F1
If no buttons are touched for 10 minutes, the screen will automatically
return to the Main display. Any settings that have not been saved will
be lost.
<Display of unsupported functions>
Unsupported function
Return:
F1
Press the [MENU] button on the
Main menu
Main display.
The Main menu will appear.
Operation
F2 F3 F4
Press [F2] to move the cursor left.
Main menu
Press [F3] to move the cursor right.
Initial setting
F2 F3 F4
Press the [RETURN] button to exit
Fri
the Main menu and return to the
Main display.
Room
Set temp. Auto
Temp. Fan
F2 F3 F4
The message at left will appear
Title
if the user selects a function not
supported by the corresponding
Not available
indoor unit model.
F2 F3 F4
en
7