Mitsubishi Electric Mr.SLIM SLZ-M FA Series Operation Manual page 10

3. Operation
3.5.2 Vane·Vent. (Lossnay)
<Accessing the menu>
Main Main menu
Operation
F1 F2 F3 F4
Operation
Vane·Louver·Vent. (Lossnay)
High power
Comfort
Main menu:
Cursor
en
F1 F2 F3 F4
Vane (vertical air direction) setting
Fri
Low
Vane Vent.
F1 F2 F3 F4
8
Select "Operation" from the Main
menu (refer to 3.5.1), and press the
[SELECT] button.
Select "Vane·Louver·Vent.
(Lossnay)" or "Vane·3D i-See·Vent.
(Lossnay)" from the Operation
menu, and press the [SELECT]
button.
Press the [F1] or [F2] button.
Press the button as indicated above
to go through the following setting
options.
Auto
Auto Step 1 Step 2
Step 3 Step 4 Step 5
Swing
Swing
Select "Swing" to move the vanes
up and down automatically.
When set to "Step 1" through
"Step 5", the vane will be fixed at
the selected angle.
Ventilation setting
Fri
Low
Vane Vent.
F1 F2 F3 F4
<Returning to the Main menu>
Operation
Vane·Louver·Vent. (Lossnay)
High power
Comfort
Main menu:
Cursor
F1 F2 F3 F4
Notes:
During swing operation, the directional indication on the screen
●
does not change in sync with the directional vanes on the unit.
Available directions depend on the type of unit connected.
●
In the following cases, the actual air direction will differ from the
●
direction indicated on the remote controller display.
1. While the display is in "Standby" or "Defrost" states.
2. Immediately after starting heat mode (while the system is wait-
ing for the mode change to take effect).
3. In heat mode, when room temperature is higher than the tem-
perature setting.
Press the [F4] button to go through
the following setting options.
Off Low High
Off Low
• The fan on some models
of indoor units may be
interlocked with certain models
of ventilation units.
Press the [RETURN] button to go
back to the Operation menu.
High